Dzięki naszym plikom cookie chcielibyśmy zaoferować najlepsze możliwe doświadczenia zakupowe wraz ze wszystkim, co się z tym wiąże. Obejmuje to na przykład odpowiednie oferty, spersonalizowane reklamy i zapamiętywanie preferencji. Jeśli Ci to odpowiada, po prostu udziel zgody na używanie plików cookie do preferencji, statystyk i marketingu, klikając „W porządku!” (pokaż wszystko) Zgodę można wycofać w dowolnym momencie za pośrednictwem ustawień plików cookie (here)
Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.
Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".
I use it for stereo FX Loop of my HX Stomp. The quality seems ok, the profile is nice and small. I wish there were more options such as this length-wise
Very useful, high quality, low profile Y-split patch
Anonimowy 28.01.2016
I was after a low profile stereo Y-insert in order to take a single stereo TRS output from a guitar pedal and feed it into L-R 2x mono inputs on another pedal.
This does the job exactly as intended, and the flat cable makes it low profile - both at plug for compactness and for cable management! I'm also able to fit two plugs next to each other (e.g. stereo outs on a TC Electronic pedal), which I wasn't able to do with pancake plugs due to their width.
Very pleased - and can also therefore recommend other EBS patch cables for their quality and low profile, not just this Y-insert.
NB - also works in reverse, ie. splitting a single stereo TRS output into 2x mono. Seems obvious, but I've seen similar questions elsewhere so thought I'd note it here!
I was after a low profile stereo Y-insert in order to take a single stereo TRS output from a guitar pedal and feed it into L-R 2x mono inputs on another pedal.
This does the job exactly as intended, and the flat cable makes it low profile - both at plug for compactness and for cable management! I'm also able to fit two plugs next to each other (e.g. stereo
I was after a low profile stereo Y-insert in order to take a single stereo TRS output from a guitar pedal and feed it into L-R 2x mono inputs on another pedal.
This does the job exactly as intended, and the flat cable makes it low profile - both at plug for compactness and for cable management! I'm also able to fit two plugs next to each other (e.g. stereo outs on a TC Electronic pedal), which I wasn't able to do with pancake plugs due to their width.
Very pleased - and can also therefore recommend other EBS patch cables for their quality and low profile, not just this Y-insert.
NB - also works in reverse, ie. splitting a single stereo TRS output into 2x mono. Seems obvious, but I've seen similar questions elsewhere so thought I'd note it here!
The quality is not very good due to the thin cables, without it I stretch it a lot as if the cable was torn a bit ... of course it is one of the few options in the trade and nevertheless it does its job well, it helps me connect to my stereo pedals at trs inputs or vice versa
These are perfect for pedal board builders.
Save space
No noise
Good plugs
Very Flexible
Well made
Only con I can think of, is that these are not designed to plug/unplug all the time. I have used over 36 of these and the 10,18 , 28cm versions and THEY NEVER FAILED ME.
