Dzięki naszym plikom cookie chcielibyśmy zaoferować najlepsze możliwe doświadczenia zakupowe wraz ze wszystkim, co się z tym wiąże. Obejmuje to na przykład odpowiednie oferty, spersonalizowane reklamy i zapamiętywanie preferencji. Jeśli Ci to odpowiada, po prostu udziel zgody na używanie plików cookie do preferencji, statystyk i marketingu, klikając „W porządku!” (pokaż wszystko) Zgodę można wycofać w dowolnym momencie za pośrednictwem ustawień plików cookie (here)
Informacja: Aby opinie na temat sprzętu umieszczane na naszej stronie pochodziły jedynie od osób mających styczność z danym artykułem, umożliwiamy wystawianie ocen jedynie naszym klientom.
Opinie można wystawiać po zalogowaniu się w centrum klienta, używając opcji "wystaw opinię".
Really neat way to split TRRS signals to get them in an out of professional gear
Frank Flanagan 17.09.2021
I am currently using two of these to split TRRS signals into and out of DI channels to connect them to professional gear while killing ground loop noise.
I have made up one TRRS to XLR cable for each channel, picking up the appropriate signal in the TRRS.
This is more flexible and neater than splitting everything on a hardwired patch panel or putting a box onto the cable with one TRRS and 3 XLR connectors.
Note: on most TRRS connections you need will to put about a 10K shunt resistor between mic and ground (to convince the PC/iPhone etc that there is a mic present) and run the signal through perhaps a 1uF ceramic cap (to block the bias voltage provided to power headset mics).
Ich hab den Splitter nicht geöffnet, aber er ist sehr leicht, wodurch er in der Hand nicht so solide wirkt wie andere. Die Funktion scheint aber gegeben und in manchen Fällen ist das geringe Gewicht vermutlich ein Vorteil.
Die Kabel rasten kräftig ein und halten gut.
Kein Klagen bisher :-)